Mast Up Sailboat Mast Raising System is an easy mast stepping device and supports your mast while trailering or storing. Now just 2 people can raise any mast. Ideal for short handed mast raising. Fits virtually any boat with an outboard rudder (see the Mast Up Cockpit version for through-hull rudder boats). Mast Up telescopes to 9-1/2 feet. First, to use my solution, your mast should have a mast base/step or tabernacle on which the mast can pivot. This is common. Next, there will need to be an attachment point on either side of the boat, aligned with the mast pivoting point—athwartships and on the same axis. You might need to get creative here because each boat is different.
The Perfect Solo MastRaising System for Small Sailboats Tropical Boating
MastMate is a system for the raising and lowering of the mast on a trailerable yacht. MastMate allows one person to raise or lower a mast single-handed. This task can be accomplished easily, quickly, and with safety. 0:00 / 10:46 DIY Sailboat Mast Raising System atomvoyager 11.3K subscribers Subscribe Subscribed 437 Share 25K views 2 years ago Here's a DIY demonstration of raising and lowering the 35'. 0:00 / 11:48 Today I try and develop a mast raising system for my Macgregor sailboat.Please consider becoming a patron: https://www.patreon.com/SailingFreeStyleOr gratuit. It takes about a minute to raise and secure the mast. Mast Raising Sequence. (1) The mast is slid back along the stern brace into position and (2) the bolt is secured to the tabernackle. (3)The mast is bench pressed from the cockpit while the line connected to the forestay is pulled. (4) I leave the lower board on the cabin cover in place to.
The Perfect Solo MastRaising System for Small Sailboats Tropical Boating
This is the newer winch style mast raising system for use on all MacGregor and Venture boats except the 26M. This system can be used if you don't have a mast raiser at all or if you want to update a block and tackle style system to the newer winch style. MacGregor 25 Mast Raising System The mast can be easily raised single handedly using this or other variation on the same theme. Total cost of construction was less than $30, Parts needed: 1 1.5x1.5 x 7' aluminum square tubing, $7 1 1500' winch $15 1 block or as in my case a medium size $2.50 caster with wheel ground into a sheave. Today I built and finished my mast raising system for my sailboat. This should make it faster setting up so I can get out sailing faster.Please Subscribe and. The critical thing to understand about this mast-raising technique is that in order for the mast and gin-pole lines to stay tight and keep the mast and gin-pole centered over the boat, the bridles must have their pivot points located on an imaginary line running through the mast pivot bolt.
Sailboat Mast Raising System YouTube
266 Share 49K views 6 years ago Andrew Price explains how to use a gin pole and assemble tackle to raise and lower a sailboat mast. This is a 30' mast on an O'Day 26, and the gin pole was made. The TallMate allows the mast to be rolled back from its travelling position so that it can be stepped preparatory to being raised. See video. The TallMate then allows the mast to be elevated to a height that makes lifting the mast easier, combined with MastMate and BabyMates, raising the mast becomes a very easy procedure. -. New TallMate walking.
Mastender™ Pictorial Step 1 One person can lift the hinged mast from its rest position on the transom support, with the boat on the trailer or in the water. Side stays and halyards are already in position. Step 2 Insert the mast-hinge lock pin. The hinge has great strength. The stays provide all the support needed. Step 3 These instructions are specific to our 2002 Macgregor 26x, but should apply to other Macgregor sailboats as well. Tools needed. Two 9/16″ wrenches. Two 1/4″ wrenches. Mast raising pole, with bolt, line and block and tackle pulley system. Winch handle. Before starting, check the mast for damage and ensure the pulleys at the top of the mast.
The Perfect Solo MastRaising System for Small Sailboats Tropical Boating
After a rig refit, the mast of Sampaguita, a Pacific Seacraft Flicka 20, was ready to be raised. Still in her Port Townsend slip, the process was, generally, the opposite of lowering, presented in 'Lectronic Latitude on June 16, 2021 — Lowering the Mast on a Small Sailboat with The Resourceful Sailor. It required the same bridle setup. The MK-II's came from the factory all set-up for Catalina's mast raising system. It uses a simple 8' gin-pole that slides into a hole at the base of the mast, and a couple baby-stays that slip into the mast with a "T"-fitting, and pelican hooks that attach to straps used to secure the halyard turning blocks to the cabin top. A couple fiddle.
